Below are all the components and variables that you can choose from.
By selecting the “Request Quote” page then you can send us a specific request, our costumer service will answer in few hours, following your needs strictly.
Below are all the components and variables that you can choose from.
By selecting the “Request Quote” page then you can send us a specific request, our costumer service will answer in few hours, following your needs strictly.
Normal panel construction, U-panel, without any internal reinforcement
U-Panels big bag with internal reinforcing strips, which, once full, avoid widening the bag.
you can choose between different fill models:
Top without closing device
Top lighter, which allows the closing device
Sleeve of varying diameter (from 30 cm to 70 cm) that allows a precise filling
You can choose between different type of botton:
The bottom completely closed, without the ability to discharge.
Sleeve of varying diameter (from 30 cm to 70 cm) that allows the totally spout of the big bag
drain sleeve and additional fabric that protects the lower valve, when closed, during the handling of the big bag
The bottom allows quick unloading big bag; It is built with 4 tubular Rails, closed by a tight loop tape that guarantees the maximum range of the big bag
two concentric valves. This solution allows to dose the emptying of the product as well as protecting the main valve.
high-performance loading system that allows the product to be piped inside quickly to the emptying spout
all our fabrics are suitable for food contact
Standard polypropylene available in the following weights:
Standard polypropylene coated with a polyethylene lamination of 30 g/m². Weights available are those shown in the next section, to which is added the weight of lamination. This fabric is usually used to avoid the release of very fine materials such as powder or flour.
we can product Big bag in different dimension
from 40 cm to 120 cm
from 40 cm to 120 cm
every height (usually the height can not exceed twice the base)
In the top of big bags are belts for lifting that allow the easy handling by forklifts or mechanical cars. The length is normally 30 cm, but, in needed, we can change the dimension.
Normal overlock stitching through thick polypropylene yarn 5000 den.
Additional seams using polypropylene yarn that close the holes that the needle creates during assembly. They are usually used in conjunction with fabric laminate, and for the containment of dusty material.
Polyethylene bag can be placed inside the big bags. It is available in different thicknesses and sizes, besides being suitable for food contact. .
Single Trip.
It has been tested at a maximum load of 5 times the declared weight (S.W.L.)
Multi trip.
It has been tested at a maximum load of 6 times the declared weight (S.W.L.)
depending on the fabric used we can offer different maximum loading loads (from 500 kg to 2000 kg)